PCB etching 101

From XPUB & Lens-Based wiki

p̞̈͑̚͞c͕͗ͤ̕̕b̬͖̏́͢ ẹ̿͋̒̕t̲̂̓ͩ̑c͕͗ͤ̕̕ḣ̖̻͛̓ỉ͔͖̜͌ṇ̤͛̒̍ĝ̽̓̀͑ 1̨̹̦͍̀0̗̜͕̅̃1̨̹̦͍̀
                                                                 


preparing the image

Preparing an image can be done in software like Fritzing or KiCad. There you will be able to produce the right pin out layout for specific components like arduino and other modules. This allows for the components to be soldered directly onto the board.

1. In Fritzing, open the breadboard tap, drag in the components of your circuit and connect them with wires. this will automatically generate a schematic drawing and PCB layout.

2. Make sure everything is connected properly and then open the PCB tab to arrange the circuit as you please.

3. Export as image (svg/png).

4. Edit your image in an image editor of choice to create a black on white vector image.

lines can be merely decorative or functional, connecting different pin outs.

printing on the copper board

marker method

mimaki flatbed printer

1. save file as .tiff or .pdf

pen plotter

etching

at the publication station:

1. Your copper plate with the image will need to be submerged in ferric chloride for around 15 minutes. You need to gently shake it for the copper to corrode.

2. When everything around the drawing is etched off, rinse it with water and then wash it off with soup. The lines covered in marker should now turn copper.

finishing it up

>drill pin holes >solder components