Prototyping for Habitat: Difference between revisions
| Line 18: | Line 18: | ||
3. '''Enable SSH on the Pi''' | 3. '''Enable SSH on the Pi''' | ||
With a screen + keyboard | ''With a screen + keyboard'' | ||
* Connect the Pi to a screen and keyboard. | * Connect the Pi to a screen and keyboard. | ||
* Run: sudo raspi-config | * Run: <code>sudo raspi-config</code> | ||
* Select Interfacing Options | * Select <code>Interfacing Options</code> | ||
* Navigate to and select SSH | * Navigate to and select <code>SSH</code> | ||
* Choose Yes | * Choose <code>Yes</code> | ||
* Select Ok | * Select <code>Ok</code> | ||
* Choose Finish | * Choose <code>Finish</code> | ||
4. '''put the SD card back in the Pi and boot it up''' | 4. '''put the SD card back in the Pi and boot it up''' | ||
Revision as of 13:26, 18 November 2021
Raspberry Installation
I followed this guide:
→ https://pzwiki.wdka.nl/mediadesign/The_Ultimate_RPi_Installation_Guide
1. Download an OS image file
2. Put image on SD Card
- Open terminal
- Find the disk that you are going to write to
diskutil list
- Find the disk /dev/disk<number>
- You need to unmount the SD Card before imaging
sudo diskutil unmountDisk /dev/disk<number>
- Then to image the disk with your image put in the following command
sudo dd bs=4m if=/path/to/your/image.img of=/dev/rdisk<number>
3. Enable SSH on the Pi
With a screen + keyboard
- Connect the Pi to a screen and keyboard.
- Run:
sudo raspi-config - Select
Interfacing Options - Navigate to and select
SSH - Choose
Yes - Select
Ok - Choose
Finish
4. put the SD card back in the Pi and boot it up