P R O T O T Y P I N G

What is a Circuit?

What are Resistors?

conversion calculator resistor color code

Light-Emitting Diodes (LEDs)

How to use Arduino?

1. Arduino Script


*
 * Zalan's first Program
 */

 int ledPin = 13;
 void setup()
 { 
  //initialize pins as outputs
  pinMode(ledPin, OUTPUT);
 }
void loop()
{ 
  digitalWrite(ledPin, HIGH);
  delay(1000);
  digitalWrite(ledPin, LOW);
  delay(1000);
}

2. Arduino Script

int LED = 12;
int BUTTON = 4;


void setup()
{
  pinMode(LED,OUTPUT);
  pinMode(BUTTON,INPUT);
}

void loop()
{
  if(digitalRead(BUTTON) == HIGH)
  {
  digitalWrite(LED,HIGH);
  }else
  {
  digitalWrite(LED,LOW);
  }
}

3. Arduino Script

int switchPin = 8;
int ledPin = 13;
boolean lastButton = LOW;
boolean currentButton = LOW;
boolean ledOn = false;

void setup()
{
  pinMode(switchPin, INPUT);
  pinMode(ledPin, OUTPUT);
 
}

boolean debounce(boolean last)
{
  boolean current = digitalRead(switchPin);
  if (last != current)
  {
    delay(5);
    current = digitalRead(switchPin);
   
  }
  return current;
  
}
void loop()
{
  currentButton = debounce(lastButton);
  if (lastButton == LOW && currentButton == HIGH)
  {
    ledOn -= !ledOn;
  }
      lastButton = currentButton;
    digitalWrite(ledPin, ledOn);
  

}

4. Arduino Script

// NeoPixel Ring simple sketch (c) 2013 Shae Erisson
// released under the GPLv3 license to match the rest of the AdaFruit NeoPixel library

#include <Adafruit_NeoPixel.h>
#ifdef __AVR__
  #include <avr/power.h>
#endif

// Which pin on the Arduino is connected to the NeoPixels?
// On a Trinket or Gemma we suggest changing this to 1
#define PIN            6

// How many NeoPixels are attached to the Arduino?
#define NUMPIXELS      16

// When we setup the NeoPixel library, we tell it how many pixels, and which pin to use to send signals.
// Note that for older NeoPixel strips you might need to change the third parameter--see the strandtest
// example for more information on possible values.
Adafruit_NeoPixel pixels = Adafruit_NeoPixel(NUMPIXELS, PIN, NEO_GRB + NEO_KHZ800);

int delayval = 500; // delay for half a second

void setup() {
  // This is for Trinket 5V 16MHz, you can remove these three lines if you are not using a Trinket
#if defined (__AVR_ATtiny85__)
  if (F_CPU == 16000000) clock_prescale_set(clock_div_1);
#endif
  // End of trinket special code

  pixels.begin(); // This initializes the NeoPixel library.
}

void loop() {

  // For a set of NeoPixels the first NeoPixel is 0, second is 1, all the way up to the count of pixels minus one.

  for(int i=0;i<NUMPIXELS;i++){

    // pixels.Color takes RGB values, from 0,0,0 up to 255,255,255
    pixels.setPixelColor(i, pixels.Color(0,150,0)); // Moderately bright green color.

    pixels.show(); // This sends the updated pixel color to the hardware.

    delay(delayval); // Delay for a period of time (in milliseconds).

  }
}