Glare module

A LDR gesture controllable sound interface

REQUIRED PARTS:

1 x GLARE circuit board
1 x Teensy 3.1 OR Teensy LC
4 x ADS1115 16 Bit I2C ADC
16 x Light dependent resistors
33 x Mono audio Jack 3,5mm model PJ301M-12
16 x Mono audio Jack Plug 3,5mm
1 x Tactile Push Button 6x6mm 15mm version if available
1 x Toggle switch ON-OFF 2 pin
16 x 480 mm 2 poled cable
16 x 500 mm shrinking tube ø6, 4mm
16 x 500 mm x 2,5 mm insulated metal wire
18 x 10KΩ Resistor
2 x 1KΩ Resistor
73 x Female Headers (optional)
73 x Male Headers (optional)
Insulating Tape
Solder

TOOLS:

Soldering iron

For the sake of brevity from now on the ADS1115 will be called ADC, the Teensy LC board will be called Teensy and the GLARE circuit board will be called PCB.

Make sure you have all the parts listed in the Parts section before you begin assembling the GLARE module! The screen printed side of the PCB must face upwards. If you want to be able to detach the main parts you should solder male and female headers to the PCB and parts. You can also chose to solder the parts directly onto the PCB.

ASSEMBLY MANUAL:

   *# Carefully detach the GLARE PCB from the main PCB
   *# Solder 33 male headers to the 3 lines of holes on the Teensy 3.1/LC
   # Solder 10 male headers to the line of holes on each ADC
   #Solder the legs of the 18 10KΩ resistors to the PCB at the labeled positions
   #Solder the legs of the 2 1KΩ resistors to the PCB at the labeled positions
   #Solder the legs of the Tactile Push Button to the PCB at the labled position 
   #Solder 33 female headers to the 3 lines of holes surrounding the Teensy 3.1/LC label on the PCB
   #Solder 10 female headers to each of the 4 lines of holes on the right side of the ADC 1, 2, 3 & 4 labels on the PCB
   #Solder the legs of the Toggle switch to the PCB at the labeled position
   #Solder the legs of the 33 Mono audio Jacks to the PCB at the labeled positions